Page 17
7700 MACHINE CHARGING INSTRUCTIONS
MACHINE CHARGING
WARNING:
Disconnect from power source before operating. Failure to do so could cause damage to machine or
bodily injury.
Figure C
Figure A
Machine has two on board chargers ( Figure A).
Note: Read & Understand charging manual before using g (pages16.1-
16.4)
• To eliminate accidental machine start-up while machine is
charging, turn off circuit breaker (Figure B) and depress E-Stop
Button (Figure C) before connecting charger to a power source.
• Connect machine to power source using supplied 6 ft 12 gauge
(4 meter 2.05mm) extension cord.
NOTE:
NOT USING PROPER SIZED
EXTENSION CORD COULD CAUSE IMPROPER CHARGING AND
/
OR CHARGER
DAMAGE
.
•
M
AKE SURE TO CONNECT EACH CHARGER INTO SEPARATE DEDICATED
POWER CIRCUITS
. 10/15
AMP
• 240 volt • single PHz (x2).
NOTE:
Charger has a tri-color light.
Red = Discharge
Yellow = 80% charge
Green = Full charge
See Manufacturers Manual (included) for further Specifications
• Complete charging sequence
• Disconnect cord from the power source. Make sure the
cord/plug is completely secure back into the machine.
Failure to do so could cause cord to fall under machine
which will cause damage to cord and/or plug.
• Turn on circuit breaker
• Release E-Stop
Figure B
WARNING:
Electrical shock hazard. Only use National’s approved charging system.
WARNING:
Always find a safe place for recharging power packs with good ventilation away from sparks or flame
sources and away from bystanders. Rope off if necessary.
Summary of Contents for All Day Battery Ride-On 7700
