Figure B
Page 27
7700 OPERATING CONTROLS
CYLINDER LIFT (FIGURE C)
The cylinder lift lever raises and lowers the cylinder and cutting head.
After setting slide plate to proper height, use the cylinder lift lever to
set blade to proper cutting angle. Pull back
on the cylinder lift
lever to raise the cutting head. Push the cylinder lift lever forward
to lower the cutting head. Continuing to push the cylinder lift lever
forward and it will adjust the angle of the cutting head. This will also
jack up the front of the machine (Figure D). This will need to be done
when doing maintenance on the machine (ie: wheel changing, front
caster maintenance etc). When doing machine maintenance, besides
raising the cutting head angle, place blocks under the machine
(Figure E). Never use the cutting head only.
Figure C
Figure D
WARNING
:
Disarm machine by removing the cutting head or dropping the cutting head to the
floor when the machine is not in use.
EMERGENCY STOP SWITCH (FIGURE A)
The emergency stop switch is designed to kill the power to the
system.
Figure E
Figure A
TO STORE MACHINE (FIGURE B)
When the machine is in storage, remove the blue plug and turn
circuit breaker to off. This will help to keep someone from operating
the machine when it shouldn’t be.
Emergency Stop Switch
SEAT SWITCH
The seat has a safety switch. Operator must be properly positioned
for machine to run.
WARNING:
Do Not alter a switch or lever. Do Not defeat a safety device.
Summary of Contents for All Day Battery Ride-On 7700
