Page 50
7700 MACHINE MAINTENANCE
SEAT REPLACEMENT
1. Remove four (4) button hexhead screws on each side of the hood (4 times).
2. Slightly raise seat plate & unplug wire harness.
3. Lift hood off.
4. Remove seat.
5. To replace seat, set seat on top of hood.
6. Replace the four 5/16 button hexhead screws from underneath the hood.
7. Firmly tighten.
8. Reconnect back-up beeper, seat switch wires and hour meter.
9. Replace hood and screws.
SWITCHES
There are three switches:
1. On (Start) Switch
2. Off (E-Stop) Switch
3. Seat Switch
WARNING:
Always disconnect from battery before maintaining.
WARNING:
Never operate machine without pump guard housing in place.
# 5200-258
DEBRIS DEFLECTOR MOUNTING INSTRUCTIONS
•Insert and secure a cutting head, making sure cutting head is
all the way
in.
•If there are holes on your lower cutting head support
, place debris
deflector under the lower cutting head support and bolt in place.
•If there are not holes on the lower cutting head support
, place debris
deflector on the lower cutting head support, measuring a 1'' clearance
between the cutting head and the front of the debris deflector. This
clearance will reduce a “pinch point”.
•Secure with C-clamps.
•Mark the holes from the debris deflector on the lower cutting head
support.
•Either drill a 1/2'' hole on each mark and secure debris deflector with a
bolt and lock nut
OR
drill a 27/64'' hole and tap 1/2-13.
•Firmly secure debris deflector under the cutting head.
Lower Cutting
Head Support
1''
Clearance
Debris
Deflector
Insert & Secure
Cutting Head
Summary of Contents for All Day Battery Ride-On 7700
