4
FILTER
POWER
TIMER
OFF/ON
Indoor unit
Names of Parts
Refrigerant piping and
inter-unit cable
Outdoor unit
Grille tab
Diffuser
Front grille
Air inlets
(Back and side)
Earth terminal:
is inside of this part.
Air outlet
Air purifying filter
Air purifying filters are
attached to the inside
of the air filters.
Air filter
Louvre (vertical blades)
The louvre is inside of the air
outlet.
(See page 8 “Adjusting the Air
Flow Direction”.)
Flap (Horizontal blade)
(See page 8 “Adjusting the
Air Flow Direction”.)
How to open the front grille: (See page “Care and Cleaning”)
CAUTION
Before opening the grille, be sure to stop the operation
and turn the breaker OFF. If the power is on, the fan may
rotate inside and may cause injury.
Opening the front grille
Receiver:
•
receives signals from the remote
controller.
•
When the unit receives a signal,
you will hear a short beep.
Room temperature sensor:
•
senses the air temperature around the unit.
Indicator lamps
TIMER lamp (yellow)
(See page 9 “Timer
Operation”.)
CLEANING lamp (red)
Lights up when the air
filters need cleaning.
(See page 10 “Care and
Cleaning”.)
OPERATION lamp (green)
ON/OFF switch
Control panel
ON/OFF switch
•
Push this switch once to start operation. Push once
again to stop it.
•
The mode is set to COOL, the air flow rate to AUTO
and the temperature to 22°C. (see page 8 “DRY/
COOL/FAN Mode operation.”)
•
This switch is useful when the remote controller is
missing.
CLEANING lamp
reset button
•
Push this button to
turn the CLEANING
lamp off.
Air inlet
Air outlet
