Using
Swing
in combination with the
Gate
parameter adds further variations in note duration.
For example, if
Gate
is set to
100%
, KOMPLETE KONTROL sends a MIDI note-off message
before each note and plays back the sequence legato. If
Gate
is set to values larger
or
smaller
than
100%
, then notes will be scaled after the value of the
Swing
parameter has been applied,
leaving the groove intact.
14.6 Setting the Other Parameters
The
OTHER
parameters
Octaves
,
Dynamic
, and
Gate
allow you to change the range of available
notes for the arpeggiator sequence, as well as their velocity and length.
The
OTHER
parameters
Octaves
,
Dynamic
, and
Gate
.
14.6.1 Other Octaves
The first
OTHER
parameter,
Octaves
, is only available in
Arp
mode. On the keyboard, it is map-
ped to Knob 6 of the Control section when Arpeggiator Edit mode is selected. It lets you de-
cide the range of the arpeggiator sequence. You can choose to play back your sequence within
the octave of only the keys you pressed on the KOMPLETE KONTROL S-Series keyboard, or
you can select up to eight octaves and let the corresponding notes of your chord or scale be
played back in as many octaves.
Depending on the settings you have made to the
Type
parameter, the octaves played back can
be above (e.g.
Up
), below (e.g.
Down
) or both above and below (
Up & Down
) the pressed keys.
The
Octaves
setting includes the following values:
▪
1
▪
2
Playing and Editing the Arpeggiator
Setting the Other Parameters
KOMPLETE KONTROL - Manual - 172
Summary of Contents for komplete kontrol s series
Page 1: ...MANUAL...
