▪
3
▪
4
▪
5
▪
6
▪
7
▪
8
To display the set value of the
OCTAVES
parameter, tap Knob 6.
14.6.2 Other Dynamic
The second
OTHER
parameter,
Dynamic
, is only available in
Arp
mode. On the keyboard it is
mapped to Knob 7 of the Control section when Arpeggiator Edit mode is selected. It reads the
velocity of the input—e.g. a key you pressed on the KOMPLETE KONTROL S-Series keyboard
or an incoming MIDI note from the host—and scales it by the factor you set with the
Dynamic
parameter. The scaling is applied per note. The velocity of each played note is taken and mul-
tiplied by the value set with the
Dynamic
parameter.
Dynamic
is a drag control that lets you set a value between
1.0%
and
200.0%
.
To display the set value of the
DYNAMIC
parameter, tap Knob 7.
14.6.3 Other Gate
The third
OTHER
Parameter,
Gate
, is available in both
Arp
and
Note Repeat
mode. On the key-
board, it is mapped to Knob 8 of the Control section when Arpeggiator Edit mode is selected.
It lets you decide the length of the notes in your sequence. Setting a value between
1%
and
99%
makes the duration of the notes shorter than they otherwise would be. Setting a value
between
101%
and
200%
instead elongates the duration of the notes by the selected value.
Gate
is a drag control that lets you set a value between 1.0% and 200.0%.
Playing and Editing the Arpeggiator
Setting the Other Parameters
KOMPLETE KONTROL - Manual - 173
Summary of Contents for komplete kontrol s series
Page 1: ...MANUAL...
