Please refer to section
2.3.3, Navigating Channel Properties, Plug-ins, and Parameter
to know how to access the
MIDI
page of the Output properties
in the software and from your controller.
Control
Description
MIDI Section
Dest.
Selects the MIDI port on which the Sound will send MIDI data.
If MASCHINE is running in stand-alone mode, available entries are
None
(MIDI output disabled, default setting), every enabled MIDI
output port, as well as any Sound in the same Group containing a
Plug-in that can receive MIDI (multitimbral Plug-in). Check the
MIDI
page of the
Preferences
panel to enable the desired MIDI
output ports on your MIDI interfaces (see
If MASCHINE is running as a plug-in in a host application, the
entries for the enabled MIDI output ports are
None
(MIDI output
disabled, default setting) and
Host
. If
Host
is selected, MASCHINE
will forward the MIDI data from the Sound to the host application.
This notably allows you to record what you play on the pads as MIDI
files in your host — e.g., for further editing, controlling other
instruments, etc.
Channel
Selects the MIDI channel on which the Sound will send MIDI data.
By default Sound slot 1 will send MIDI data on channel 1, Sound
slot 2 on channel 2, etc.
Transpose
Applies an offset to the MIDI note numbers before the notes are
sent. Values range from -48 (downward transposition by 48
semitones, i.e. four octaves) to +48 (upward transposition by 48
semitones, i.e. four octaves). The default value is 0.
Configuring MIDI Output for Sounds in Mix View
You can also easily configure the MIDI output of your Sounds in MASCHINE’s Mixer:
Audio Routing, Remote Control, and Macro Controls
Using MIDI Control and Host Automation
MASCHINE 2 - Manual - 331
