In order to record modulation, your keyboard provides an Auto-write mode similar to the one
found on the various MASCHINE controllers, except that on your keyboard Auto-write mode is
always pinned (it is never a temporary mode).
To record modulation from your keyboard, do as follows:
1.
Check that MASCHINE’s playback is on.
2.
On your keyboard, press
SHIFT
+ Page Left + Page Right simultaneously to enter Auto-
write mode.
The leftmost display reads
AUTO ON
. While you are holding
SHIFT
, both Page buttons are
fully lit to indicate that Auto-write mode is active.
In the displays under Knobs 1–8 parameters that cannot be modulated disappear and the
corresponding Knobs above are disabled. For modulatable parameters the bars switch to
bipolar mode and the values (appearing only when you touch the Knobs) indicate the de-
viations to the actual values, measured in percentage:
3.
Turn the desired Knobs 1–8 above the displays to record deviations to the actual values.
Your modulation gets recorded now. Each Knob movement is stored in your Pattern as a
modulation event. It will be automatically played with your Pattern upon its next cycle.
4.
When you’re done, press
SHIFT
+ Page Left + Page Right again to quit Auto-write mode.
The leftmost display shortly reads
AUTO OFF
. While you are holding
SHIFT
, both Page
buttons are dimmed to indicate that Auto-write mode is inactive.
At any time you can check whether Auto-write mode is active or not by holding
SHIFT
on your
keyboard: If Auto-write is enabled both Page buttons will be fully lit, otherwise both Page but-
tons will be dimly lit.
The Auto-write mode of your keyboard and that of any MASCHINE controller simultane-
ously connected are independent from each other: You can enable and use Auto-write
mode on either device without affecting the functionality of the other device.
KOMPLETE KONTROL Integration
Recording Modulation from Your Keyboard
MASCHINE 2 - Manual - 689
