The SOLID EQ user interface.
The four sets of colored knobs represent the four main frequency band of your equalizer.
(1)
LF
section: controls for the low frequency band.
(2)
LMF
section: controls for the low-middle frequency band.
(3)
HMF
section: controls for the high-middle frequency band.
(4)
HF
section: controls for the high frequency band.
These four sections hold the following controls:
Control
Description
Hz
or
kHz
knob
Adjusts the band’s center frequency. Thus, this parameter sets the overall
position of that frequency band in the spectrum. For the
LF
,
LMF
, and
HMF
band, the frequency is measured in hertz; for the
HF
band, it is
measured in kilohertz.
dB
knob
Adjusts the amplification gain (i.e. the amount of cut/boost) at the band’s
center frequency, in decibels. With the knob at the center position, the
frequency band is left untouched.
Using the SOLID EQ
The Main Interface
Solid EQ - Manual - 11
Summary of Contents for SOLID BUS COMP
Page 1: ...Manual...
