ZephIR user manual QP1009-582 v2
© Natural Power 2008
10
th
June 2008
Page 20
1.
E1 to O1 Focus Encoder
(QP0000-601) provides interconnection between the
electronics pod and the optics pod for focus encoder
signals.
2.
E2 to O2 System Control (1)
(QP0000-603) provides interconnection between the
electronics pod and the optics pod for the primary system
control.
3.
E3 to O3 System Control (2)
(QP0000-604) provides interconnection between the
electronics pod and the optics pod for the secondary
system control.
4.
E8 to O8 Optics Power
(QP0000-611) provides interconnection between the
electronics pod and the optics pod for the optics pod
power supplies.
5.
E7 to O7 Focus Motor
(QP0000-602) provides interconnection between the
electronics pod and the optics pod for the focus motor
drive power.
6.
E9 to O9 Detector Signal
(QP0000-947) provides interconnection between the
electronics pod and the optics pod for the detector signal
acquisition.
7.
E5 Fans
(QP0000-617) provides interconnection between the
electronics pod the fans situated on both the optics pod
and the electronics pod.
8.
E6 to GSM / GPS
(QP0000-617) provides interconnection between the
electronics pod and the GSM / GPS aerial situated on the
top of the Met Mast. The relevant cable can be found at the
base of the met mast.
9.
E12 to Met Station
(QP0000-649) provides interconnection between the
electronics pod and the Met Station situated on the top of
the Met Mast. The relevant cable can be found at the base
of the met mast.
10. E10 to B10 Wash
(QP0000-606) provides interconnection between the
electronics pod and the battery pod for the wash system
monitoring.
11. E11 to Spare
This port is used for upgrading the ZephIR firmware.
12. E4 to B4 System Power
(QP0000-607) provides interconnection between the
electronics pod and the battery pod for the supply of system
power from the d.c. regulators and batteries contained in
the system.
13.
Primary Power Input
Primary Power supply into the system is provided from a
110/240 to 24-28 d.c. power supply.
