Electronic pellet burner controller – NPBC-V3C-1/ NPBC-V4C-1
Factory Settings
These menus concern the burner's general control, burning process and safe usage. Because of the
importance of these parameters, the access to the Factory Settings can be restricted with an access
code. This option is disabled by default. To enable it go to the menu
Factory Settings → Change
Code
.
Press and hold the Menu button for more than 2 seconds to enter the Factory Settings. If the access
code is enabled, the first screen requires its input:
Press the up or down navigation button (
▲
▼
) to change the value for each position and the left/right
buttons (
◄ ►
) to switch between positions. Confirm the code with the Menu button (
). Some of the
parameters in the Factory settings are common for all types of fuel, but others depend on the fuel type.
NPBC-V3C supports settings for 4 different types of fuel. Adjust the parameters for each fuel type by
accessing its profile from the sub-menu Burning Setup:
To go back to the previous screen, press the left navigation button (
◄
).
User Manual / ver 3.8
http://www.naturela-bg.com/en/
page 26 of 36
Access this screen by
pressing the right button (
►
)
on the row Burning Setup
Access this screen by
pressing the right button (
►
)
on the row Fuel 1
