Controller for pellet oven – NPBC-V3C-B
Factory Settings
These menus concern the burner's general control, burning process and safe usage. Because of the
importance of these parameters, the access to the Factory Settings can be restricted with an access
code. This option is disabled by default. To enable it go to the menu
Factory Settings → Change
Code
.
Press and hold the Menu button for more than 2 seconds to enter the Factory Settings. If the access
code is enabled, the first screen requires its input:
Press the up and down navigation buttons (
▲
▼
) to change the value for each position and the left
and right buttons (
◄ ►
) to switch between positions. Confirm the code with the Menu button (
)
Some of the parameters in the Factory settings are common for all types of fuel, but others depend on
the fuel type. NPBC-V3C supports settings for 4 different types of fuel. Adjust the parameters for each
fuel type by accessing its profile first from the sub-menu Burning Setup. After that, select the fuel type
and then the sub-menu with the parameters you want to adjust:
User Manual / ver 3.7
http://www.naturela-bg.com/en/
page 22 of 30
Access this screen by
pressing the right button (
►
)
on the row Burning Setup
Access this screen by
pressing the right button (
►
)
on the row Fuel 1
More options
available on
the next page
