Controller for pellet oven – NPBC-V3C-B
I
NTRODUCTION
NPBC-V3C-B
is a new updated version of the popular controller NPBC-V3M-1. It works with a
new Control module with a color TFT display NRC-6 and NPBC-V3M Executive module. This
model's most important advantages are:
•
Clearer and intuitive user interface with modern looking menus and 6 control buttons.
•
Additional warning messages about incorrect parameter input or if parameters from a different
menu require corrections after the current changes.
•
The Control module can be equipped with a WiFi module NRM-W3 for connection with the
Naturela remote monitoring and control system through the web
•
4 preset fuel profiles make switching between different fuels easier than ever
•
Statistical information about the fuel consumption divided by hour and based on a calibrating
constant parameter for the fuel auger's capacity.
•
A list with short description, date and time of the occurred errors and any other event
concerning the controller's work.
•
More parameters about the burner's work and current state displayed on the main screen at the
same time
•
A micro USB coupling on the face panel of the Control module for connection with a computer
with software for direct control and monitoring.
The controller
NPBC-V3C-B
is designed to run burners, which use a photo sensor to detect the
burning fire. The pulsing control of the auger motor from the pellet tank allows the precise dosing of
the amount of pellets that goes to the burner.
NPBC-V3C-B
can control an optional internal auger
motor that forwards the pellets inside the burner. The controller runs two blowers: one that provides
the air to the burning chamber and the other is an additional fan, for example, for taking out the
exhaust gases from the boiler, if necessary. Both blowers' power can be adjusted from the controller.
NPBC-V3C-1 has an option to measure and control the temperature of the exhaust gases with a high
temperature sensor pt100, mounted in the entrance of the vent. For more effective cleaning process the
controller can also run an additional powerful fan to blow away the ashes from the burning chamber or
a mechanical cleaning mechanism with an option to be run by one controlling or powering up voltage.
All of the controlled mechanisms must work on 220VAC or 110VAC mains power supply!
User Manual / ver 3.7
http://www.naturela-bg.com/en/
page 3 of 30
