Electronic pellet burner controller - NPBC-V3M
2
nd
level -
Setup
- adjust the work mode for 2
nd
power level. Set the active time of the auger
when loading a portion of pellets, the cycle time before loading a new portion of pellets and the speed
of the fans.
1
st
level -
Setup
- adjust the work mode for 1
st
power level. Set the active time of the auger when
loading a portion of pellets, the cycle time before loading a new portion of pellets and the speed of the
fans.
Suspend
– adjust the Suspend mode. Set the active time of the auger when loading a portion of
pellets, the cycle time before loading a new portion of pellets and the speed of the fans. Settings here
are the same as above.
Smooth extinction of the fire –
Burning Shutdown
–
When the room thermostat activates due to
reaching the set temperature while the controller is working in
CH Priority
mode, the burner
smoothly decreases the power level and if the room thermostat remains active, it shuts down. The
burner goes through each power level and works on it for as long as it is set in the menu below:
User Manual / version 2.6
http://www.naturela-bg.com/en/
page 18 of 27
If the burner is working on
this power level, in 60 seconds
it will switch to the lower one
