Electronic pellet burner controller - NPBC-V6T-2
When the burner is turn
On
, at first it will be displayed the field “Number of fuel”. If all the
conditions for ignition of the burner are fulfilled, as for example - the temperature of the boiler is
under the set hysteresis for ignition, there is no active room thermostat, no active input OD for
emergency stop, no registered serious problems and there is permission, and any the timers are on,
the burner will turn on to ignition automatically. After that, all the procedures for this type of fuel
will be automatically performed – ignition, unfolding the fire, suspend, power modulation,
intermediate cleaning, extinguishing and full cleaning.
When Timers mode is selected, the burner will run only the set time intervals from menu
“Timers”. If all the timers get deactivated, while the burner is running in “Timers” mode, the
burner will stop and an error will be displayed - “No active timers!”. If in this situation, at least
one timer is activated again, the burner will continue to operate in “Timers” mode, according the
active timers.
Changing the set temperature for heating the water in the boiler
By pressing the button , when the controller is in “Main screen” the user is opening the screen
for correction of the set temperature. The temperature is changed with the virtual button "+" and
"-". When holding one of these buttons, the temperature will change automatically with a rate to 5
degrees per second. To exit and save the temperature, press the
button. If no button is pressed
for 5 seconds, any change made, is saved and exits to the main screen.
Easier way for correction
is possible, by sliding the finger up to the screen for increasing the temperature or down to the
screen for decreasing it. If slide the finger to the left you will saved the new temperature and you
will exit from the temperature screen.
Additional information for the burner operation.
By pressing a button , when the controller is in “Main screen”, you go to additional information
screens. Switching over from main screen to information screens can be done and by gesture –
sliding on the left.
User Manual / ver. 1.2
http://www.naturela-bg.com/en/
page 19 of 41
Available area for
operating by
gestures
