Electronic pellet burner controller - NPBC-V6T-2
Service settings
These menus concern the burner's general control, burning process and safe usage. Because of the
importance of these parameters, the access to the Service Settings can be restricted with an access
code. This option is disabled by default. To enable it go to the menu Service Settings
»
Change
Code. Press and hold the Menu button for more than 2 seconds to enter the Service Settings. If the
access code is enabled, the first screen requires its input:
When entering the code by the virtual keypad, the last digit is displayed for 2 seconds, after which
it is replaced by the symbol "*" for security reasons.
After entering all digits from the access code you must press the button to confirm it. If the
code is correct, the Service Settings sub-menu screen is displayed. If the entered code is incorrect,
the corresponding message is displayed, after which it is only possible to return to the main
screen. If no code is entered, it will automatically return to the main screen.
The controller NPBC-V6T supports settings for 4 different types of fuels. Some of the settings do
not depend on the fuel and they are general for all types of fuels. Most of the parameters are
individual for each type and are available trough a menu
“Service settings”
» Burning Setup
»,
where you have to choose
''Fuel 1'', ''Fuel 2'', ''Fuel 3''
or
''Fuel 4''.
User Manual / ver. 1.2
http://www.naturela-bg.com/en/
page 30 of 41
