17
Troubleshooting
My Nature’s Generator won’t charge when I connect my solar panel to it.
Please follow these steps.
1. Make sure the solar panel is pointed directly towards the sun. It is preferred to posi�on the solar
panel facing south. The solar panel may produce li�le or no power if it is posi�oned in the shade.
2. Check the cable connec�on on your
Nature's Generator and make sure it is properly connected.
3. The LCD lights up but the ba�ery bar is not running. It means the Nature's Generator has been
fully recharged by the solar panel or the solar panel does not have high enough voltage to recharge
the Nature's Generator.
My AC device(s) are not powering up from my Nature’s Generator.
Please follow these steps:
1. Verify your device is suitable for use with your Nature's Generator. The Nature's Generator AC
outputs work only with 120V AC and up to 1800 wa�s on three outlets combined.
2. Make sure the Main Power Switch is turned on.
3. Check the ba�ery bar. If there are only three bars or less, recharge your
Nature's Generator.
Some AC devices draw large amounts of power and it is recommended to recharge your Nature's
Generator full before heavy use.
4. Make sure the AC outlet switch is turned on. The LED light should be green.
5. If LED light is red, please check the failure icons on the LCD display.
a. Ba�ery Fail Icon: replace your ba�ery.
b. Ba�ery Low Icon: recharge your ba�ery before use.
c. Temperature Warning Icon: The internal temperature is too high. Please let it cool down before
trying to use again.
d. FUSE Icon: Replace the fuses.
e. AC! Icon: The AC inverter is being protected. Unplug your AC device, turn off AC outlet switch
and back on to try it again.
My Nature’s Generator battery drains fast.
Please follow these steps.
1. Check the wa�age of your AC device(s). Some devices like a hair dryer, microwave or vacuum
draw large amounts of power and thus the ba�ery drains fast. Please always monitor the wa�age
output informa�on on the LCD display.
2. When your AC device is not in use, turn off AC outlets of your
Nature's Generator to conserve
power. The AC outlets consume a considerable amount of power while being in standby mode.
3. When Nature's Generator
is not in use, turn off the Main Power Switch and to eliminate
unnecessary ba�ery drainage to shut off the LCD display and USB ports.
Visit Naturesgenerator.com for More Information
