https://www.naturewater.eu
Item 50877–50880
Page 3
08 2022-1
Introduction
Thank you for purchasing this quality product.
To minimise the risk of injury we urge that our clients
take some basic safety precautions when using this device. Please read the operation instruc-
tions carefully and make sure you have understood its content.
Keep these operation instructions safe.
•
Our double water filters are equipped with a 10″ 5
μ sediment fine filter and a 10″ 5
μ activated
carbon block, which produce high-purity water. They are very reasonably priced and easy to
install and handle. In terms of quality and filter performance, the system corresponds to systems
that are offered at significantly higher prices.
•
Depending on the filter inserts used, the system is the solution for almost all water impurities.
•
The water filter system offered here comes with a 5
μ sediment filter insert and a 5
μ activated
carbon block filter insert, which reliably remove sand, rust, algae, and other suspended particles
from the water.
•
Of course, the 10″ (254
mm) filter inserts used here can be exchanged and replaced with other
materials as required. A complete list of all suitable filter inserts can be found in the table below.
Note:
Sediment filters are not washable and must be replaced approximately every 6
months
(DIN 1988).
•
The system does not contain any RO membrane (reverse osmosis) or ion exchanger. This
means that the vital natural mineral content is largely preserved and the water hardness is only
very slightly affected.
Technical data
1
st
filter stage
Product name
5
μ sediment filter PP-10
A (item 50820)
Max. Flow rate – filter medium
(
ℓ
⁄
h
)
800 at 20
℃
water temperature
Filter efficiency
(%)
98
Filter unit
(μ)
5
Max. Operating pressure
(
㍴
)
6
Max. Pressure loss
(
㍴
)
2
Max. Temperature
(
℃
)
30
Height
(
㎜
)
254 (10″)
Diameter
(
㎜
)
60
Inner diameter
(
㎜
)
27
