3.
The plastic cover is removed by gently pulling it up from the base. Use caution; the
cover may fit tightly onto the enclosure.
4.
If you are replacing the plastic cover, obtain the replacement and reverse the previous
steps. During replacement, take care to place the cover over the foam cushioning strips.
Verify that the foam strips are properly adhered to the base. Press down any strips that
may have lifted. Use care when routing switch and LED cables so that they do not
interfere with fan operation or become pinched in between cover and base.
Recommended torque is 15 in. lbs.
5.
If no further repair is required, return to Chapter 2, and complete Performance
Verification and Safety Tests. If further disassembly is required; store the plastic cover
in a protected area and proceed to Section 4.2, removing the LED PCB.
4.2
Removing the LED PCB
The procedure in Section 4.1 must be completed before beginning these steps.
1.
Unplug the power connector [JP2], power switch connector [JP1], temperature warning
LED connector [JP3], and Fan PCB [JP4] from the board. Note connector orientation for
replacement.
2.
Clip and remove the cable tie securing the power connector ferrite from the board.
3.
Remove the four Phillips head screws securing the LED PCB to the light enclosure.
Locations are circled in Figure 6.
Figure 6 – Removing the LED PCB
neoBLUE® cozy Service Manual
16
P/N 051915 Rev.
D