RC40 Control manual
61
e0x0058
Error writing
conveyor tracking
parameter
Parameter file writes
exception
Contact technical support
e0x0059
Error reading
conveyor tracking
parameter
Parameter file writes
exception
Contact technical support
e0x0060
Failed to load
module
Load controller modules error Contact technical support
e0x0061
System update
abnormal, the
system has been
restored
automatically
The wrong system update file
"sys.bin" was downloaded,
resulting in the failure of
normal initialization of the
controller, and the controller
was automatically restored to
the factory installed version;
Determine whether the
system update file is
damaged, ask the technical
support for the correct
update file and update
again;
e0x0062
Number of axises
mismatch
Robot body model set by
project is different from the
robot model set by controller.
Modify the robot setting and
match the model set by the
controller with the robot
body.
e0x0063
CRC check error
for the PC and
controller files
The projecty files of the active
project and the controller are
different and cannot pass
CRC check
Re-synchronize the files of
the current active project
into the controller, or upload
the files in the controller
locally;
e0x0064
Z-axis limit height
setting error
Error in z-axis limit height set
by JUMP instruction in run
mode of TEACH mode.
Modify the z-axis limit height
to ensure that the z axis of
both the starting point and
the target point are lower
