RC40 Control manual
91
e0xFF03
Encoder writing
error
1.The encoder connection
error;
2.The encoder cable damage;
3.The encoder is damaged;
1.Check the encoder
connection;
2.Check the encoder
cables;
3.Replace the encoder;
e0xFF29 CPU overload
1.Control instruction than
CPU load capacity;
2.Drive damage;
1.Reduce the control
instruction operation
frequency;
2.Replace or repair the
drive;
e0xFF15
Drive output lack-
phase
1.motor power line bolt;
2.motor damage;
3.The damage of the drive
1.check the motor power
line connection;
2.Replace or repair the
motor;
3.Replace or repair the
drive
e0xFF80
Encoder operation
failed
1.The encoder connection
error;
2.The encoder cable damage;
3.The encoder is damaged;
4.The encoder parameter
setting error
1.Check the encoder
connection;
2.Check the encoder
cables;
3.Replace the encoder;
4.Check the encoder
parameters
e0xFF25
Drive instantaneous
overload
1.Output short-circuit;
2.Due to the interference
misoperation;
3.The control parameters are
unreasonable;
4.Drive damage;
1.Check the output side of
the cable connection;
2.Reliable grounding
connection;
3.To adjust the control
parameters;
