GV60 TROUBLESHOOTING MANUAL
RESPONDING TO ALARMS
VERSION 1.0 2018-01-01
PAGE 4.1.71
Exciter/Control PWB Replacement - Exciter
Using
as a guide, replace the exciter module’s exciter/control PWB (A5A1 or A6A1) as
follows:
Figure 4.1.26: Exciter/Control PWB Location - Exciter
1.
Remove the exciter module (A5 or A6, as applicable) as described in
.
2.
Place the exciter module on a suitable work surface. Remove the bottom cover. Retain hardware
for re-installation.
3.
Disconnect all mating plugs from the exciter/control PWB (A1), inside the exciter.
BOTTOM VIEW
(cover removed)
EXCITER/
CONTROL
PWB
A1
Summary of Contents for GV60
