Page 18
Remote Text Message Access
VTracker information can be seen and modified via the Nautic Alert Mobile App, or via text message
commands. The following is a list of text message commands supported:
o
“?” Displays list of commands available
o
“Alerts on” enables sending alerts
o
“Alerts off” disables sending alerts
o
“Arm” Arms system, resets latched alarms, sets geofence to current position
o
“Disarm” Disarms system, resets latched alarm
o
“Clear” Clears latched alarms
o
“Map” Returns Google Maps link to on-demand current location
o
“GPS” Returns on-demand coordinates, heading, and speed
o
“Geofence” Returns on-demand geofence status and drift distance
“Geoefence Reset” – resets current center point of geofence
“Geofence set 50”—sets geofence radius to 50’. Mimimum radius of 250 is
recommended for stock antennas, 50’ is possible with high-performance
antennas mounted properly externally and free of obstructions.
“Geofence on”—enables the geofence and resets the center point if the
geofence is currently disabled
“Geofence off”—disables the geofence
o
“Status” Returns on-demand system status summary
o
“DC” Returns on-demand voltage from primary battery
o
“Switch on”- turns switch on if zone 1 is not setup as an SOS type
o
“Switch off”- turns switch off if zone 1 is not setup as an SOS type
Admin and Additional Users
The cell number of the owner provided when activating VTracker is considered the system
administrator. Additional users can be added via the Nautic Alert Mobile App system info Device Info
category.
Users also have remote access to the system, but do not receive Cloud Watch anti-theft notifications or
Global Geofencing notifications as discussed in the
