11
GB
16. Use the double ended pipe brush and clean the
inlet tube which runs through the base of the head unit.
Fig 5
17. Pull the rubber end cap off the shaft of the impeller
and run water through the hole in the middle of the
impeller. Clean any debris which may have built up
on the shaft off, along with any slime build up on the
impeller. Fig 6
Cleaning your filter
Fig 5
Fig 6
Rubber End Cap
Impeller
18. Put the impeller back together and ensure that it
rotates freely on the shaft. Then reassemble the head
unit, ensure there is no water on the power cord, plug
the head unit in and turn on. Make certain the impeller
is spinning. Turn it off. Reassemble the filter unit. Apply
an aquarium safe lubricant to the O-ring on the head
unit. This will provide a better water seal and make the
removal of the head easier next time the filter has to be
disassembled for maintenance.
19. Check your inlet, outlet tubes and hoses. If residue
has built up on the inside of them remove them from the
aquarium. Take to the sink, run hot water through them
to loosen the slime. Run a double ended pipe brush
through them, and flush again with hot water. This build
up will reduce the flow rate of your filter considerably,
so clean when ever it is possible.
20. Return the canister filter to your cabinet or stand
and reattach the taps.
21. Refer to the section in this instruction manual
Starting You Filter for details on restarting the unit
Trouble Shooting
The filter unit is leaking
1. Check that all o-rings are in place and that they are
not damaged or soiled.
2. Re-apply aquarium safe lubricant to o-rings.
3. Check that the media baskets are aligned properly.
4. Ensure that the quick release tap connector is
inserted correctly and locked into position.
The filter will not prime
The filter will not start
Low water flow
1. Check the tubing for kinks.
2. Ensure that the quick release tap connector is
inserted correctly and locked into position.
3. Check that the aquarium is filled with water.
4. Make sure that the intake pipe and/or intake strainer
are not blocked.
5. Ensure that the hoses are connected to the unit
correctly. IN to IN and OUT to OUT.
6. Ensure the canister has no water in it.
1. As previous tips.
2. Check the impeller and shaft are in good condition.
3. Verify that the filter is plugged in.
1. As both previous tips.
2. Clean the filter media.
3. Clean the inlet and outlet pipes.
4. Clean all tubing.
Both water & air coming from
the outlet pipe
1. Leave for 3-5 minutes.
2. Make sure that no air stone is operating near the
intake strainer.
3. Check all tubing is connected firmly.
4. Check all o-rings and re-apply aquarium safe
lubricant.
5. Gently rock the filter back and forth trying to discharge
the air in the canister.
The filter is making noise
1. As per previous tips
2. Outlet or inlet flow is restricted. Check tubing.
Summary of Contents for Aqua One 600
