Document #: SM-QTY-F-133
Rev. Level: C
Release
Date:
7/23/08
Page
2
of
2
M
ECHANICAL
R
UN
T
EST
Console Should Turn On With One Crank Of Pedals
Verify Quick Start And Level Keypads Work Properly
Configure Console For Appropriate Bike If Needed ( ^ 8 )
Configure Console For Proper Language If Needed ( ^ 3 )
U
NIT
Check And Record Unit (Standard or Metric) Configuration ( ^ 3 )
V
ER
.
Check And Record Software Version ( ^ 4 ) V21
Run Display Test ( ^ 6 ) And Verify Consistent Lighting And All Segments Present
Select Quick Start Mode – Slowly Run Up Through Levels 1 To 20; Stop At Levels 1, 5, 10, 15,
And 20 For 5 To 10 Seconds Each; Run Back Down To Level 1. Be Alert For Noises, Vibration,
And Differences In “Feel” And Resistance
Verify Information During Scan Mode
Verify Upper And Lower CHR Function
Check Battery Voltage Is 6.3 Volts Minimum
P
ASSED
N
AME
D
ATE
/
/
Reinstall shrouds
F
INAL
I
NSPECTION
Check Shrouds For Scratches, Cracks, Cleanliness, Proper Fit, Etc.
Verify Shroud Mounting Hardware Secure
Verify Pedals Secure After Shrouds Installed
Run Test After Shrouds Installed To Ensure Proper Fit
Verify Water Bottle Holder Secure (U916 Only)
Verify CHR Plates Stretch-Wrapped
Check All Decals And Console Overlay For Scratches, Air Pockets, Alignment, Etc.
Verify Serial Number Matches Work Order Paperwork
Verify Shipping Box Content Correct (See BOM)
Step 2: Apply Rework Sticker Adjacent to Serial Number Plaque.
P
ASSED
N
AME
D
ATE
/
/
24
