37
Nautilus® Commerical Series Bike Service Manual
Mechanical Procedures
U916 and R916 Procedures
REMOVING THE CONSOLE:
Tools needed:
• Phillips screwdriver or Cordless drill with Phillips tip
Step 1:
Remove the four Phillips screws attaching the Console
to the Mast. See
Figure 1a
and
1b
.
Set the screws aside for Step 5.
Step 2:
Tilt the console forward and disconnect all the cables
from the Mast to the PC board connectors (
Figure 2
).
Note:
Make note of each cable and the location of its
connector on the PC board.
Step 3:
Remove the Console.
Step 4:
To replace the Console, position the Console at the top
of the Mast so that you can connect the cables to the
PC board (
Figure 2
). For specific connector locations,
refer to the CABLE CONNECTIONS segment later in
this section.
This section of the Service Manual provides instructions for removing and replacing parts of the U916 and R916
bikes. The first segment contains procedures that apply to both bike models. The second segment contains
instructions specific to the U916 bike, and the third contains instructions specific to the R916 bike. The fourth
segment focuses on the cable connections for the U916 and R916 bikes. For part number information, please
refer to the separate documents for warranty parts lists and exploded drawings.
figure 1a - U916 console
figure 1b - R916 console
figure 2 - Cable connections in back of
Console (R916 console shown)
Summary of Contents for Be Strong Commercial R916
