11
Nautilus
NS
600X
75
42
61
16
20
19
18
Top View
Path
69 1/2"L
72
76
3 1/4"L
77
74
17
Step 3 Components:
Procedure:
ASSEmBLY
STEP 3
# Component
Qty
16
17
18
19
20
42
61
69
72
74
75
76
77
Pec Fly Mount
Pec Fly Cam
Right Pec Fly Arm
Left Pec Fly Arm
Pec Fly Handle
Plastic Cap
Hex Bolt 3/8” x 3 1/4”L
Cap Head Allen Bolt 1/4” x 1/2”L
Threadlock
1 3/8” x 1/2” Flat Washer
3/8” Flat Washer
Shim Washer
1/2” Lock Nut
3/8” Lock Nut
1
2
1
1
2
4
2
2
4
4
4
4
2
a.
Attach Pec Fly Mount (16) to Main Base using hardware shown. Tighten hard
ware firmly.
B.
Slide Pec Fly Cam (17) onto Left Pec Fly Arm (19) paying close attention to the
orientation shown above. Attach the Left Pec Fly Arm (19) to the Pec Fly Mount
(16) using the hardware shown. Tighten hardware securely making sure that the
Pec Fly Arm can rotate freely.
c.
Repeat step B using the Right Pec Fly Arm (18).
D.
Install Pec Fly Handle (20) in the Left Pec Fly Arm (19) using the hardware shown.
Tighten hardware securely making sure that the Pec Fly Handle (20) can rotate
freely. Install Allen Bolt (69) to Pec Fly Handle (20) as shown. Tighten firmly.
NoTe:
Make sure that the path of the Pec Fly Handle is similar to the path shown
in the Top View.
e.
Repeat step D using the Right Pec Fly Arm (18).
f.
Install Plastic Cap (42) in the four locations shown. The Plastic Cap (42) should
snap into place locking around the Shim Washer (75).
NoTe:
Rubber Mallet may be needed to install Plastic Cap.
