1
Step 6 Components:
Procedure:
ASSEmBLY
STEP 6
51
50
49
52
48
32
90
68 1"L
# Component
Qty
a.
Slide Weight Stack Cushion (51) on each Guide Rod (52) allowing approximately
3 inches of Guide Rod showing below the Weight Stack Cushion (51). Insert
Guide Rods (52) into holes in the Calf Raise/Low Pulley Frame as shown.
B.
Slide Weight Stack Bottom Plate (50) on top of Weight Stack Cushions (51).
c.
Place Nineteen Weight Plates (49) and the Top Weight Assembly (48) on the
Guide Rods (52) as shown. Install Weight Plates (49) so that the selector pin hole
faces forward and is located on the bottom of the plate. Install the Top Weight
Assembly (48) so that the head of the bolt is facing forward. This gym is supplied
with individual weight plate numbering decals that should be applied to the gym
after the weight stack is assembled.
D.
Slide Guide Rod Holder (32) on the top of the Guide Rods (52) and attach the
Guide Rod Holder (32) to the Top Stack Support Frame using the hardware shown.
Tighten hardware securely.
e.
Place Weight Selector Pin (90) in the bottm Weight Plate (49).
32
48
49
50
51
52
68
90
Guide Rod Holder
Top Weight Assembly
Weight Plate
Weight Stack Bottom Plate
Weight Stack Cushion
Guide Rod
Cap Head Allen Bolt 1/4” x 1”L
Threadlock
Weight Selector Pin
1
1
19
1
2
2
2
1
