16
ASSEmBLY
STEP 8
Step 8 Components:
Procedure:
# Component
Qty
a.
Attach Two 4 1/2” Pulleys (44) to the brackets shown in detail A using the hardware
shown. Tighten hardware securely.
B.
Remove the Ball, Washer, and U-Bracket from one end of Cable #2 (54).
c.
Attach looped end of Cable #2 (54) to the Pulley Mount bracket using the hardware
shown in detail A.
D.
Route Cable #2 (54) around the 4 1/2” Pulley located on the Leg Extension
assembly and around the 4 1/2” Pulley on the Pulley Mount Bracket. Proceed by
routing the Cable around the lower Pulley on the Double Floating Pulley Bracket
(30) as shown.
e
. Route Cable #2 (54) around the 4 1/2” Pulley on the Pec Fly Double Floating Pulley
Bracket (30). Continue by routing Cable over the 3 1/2” Pulley in the bracket on the
Front Upright and over the 4 1/2” Pulley adjacent to it.
f.
Re-install the Ball, Washer, and U-Bracket to the end of the cable. Be sure that the
rubber o-ring is in its original position.
30
44
54
63
64
74
77
80
81
Pec Fly Double Floating Pulley Bracket
4 1/2” Pulley
Cable #2 - Mid-Pulley Cable
Hex Bolt 3/8” x 2 3/4”L
Hex Bolt 3/8” x 2 1/4”L
3/8” Flat Washer
3/8” Lock Nut
Step Spacer 1”H
Step Spacer 21/32”H
1
2
1
2
1
2
3
2
2
77
80
81
74
63
54
44
30
64 2 1/4"L
2 3/4"L
A
B
C
96.75" (2460mm)
NS600X Press Arm
