9
Nautilus
NS
600X
10
6
5
4
3
2
1
77
74
62 3"L
62 3"L
62 3"L
59 4 1/4"L
58 4 1/2"L
61 3 1/4"L
59 4 1/4"L
61 3 1/4"L
10
10
74
77
1
2
3
4
5
6
10
58
59
61
62
74
77
Procedure:
ASSEmBLY
STEP 1
Before assembling this gym, please be aware that this piece of equipment can be assembled in two different configurations.
The Weight Stack can be assembled on either side of the gym depending on what best fits your living space. This is accomplished simply by
assembling the Rear Frame (2), Top Stack Support Frame (8), and Calf Raise / Low Pulley Frame (7) on the opposite side of the machine.
This gym is supplied with an instructional work out diagram which is to be adhered to the Rear Frame (2) back panel. See note in diagram above
for recommended location.
The following assembly instructions show the gym assembled with the weight stack on the left side. To assemble the gym with the weight stack on
the right side, simply assemble the Rear Frame (2), Top Stack Support Frame (8), and Calf Raise / Low Pulley Frame (7) on the opposite side of
the machine as shown in the instructions.
Be sure to place the NS 600X gym as close to its final location before adding weight plates. The gym is designed so that the rear of the frame can
sit directly against a wall. Please allow a minimum of 24” on each side of the gym from the nearest wall or obstruction. The weight stack side of
the gym will need a minimum of 48” from any obstruction. If an attachment such as a leg press is used now or in the future, please allow for 48” on
the side opposite the weight stack.
Recommended location for instructional
work out diagram.
2
7
8
7
2
8
NS600X Press Arm
#
component
Qty
Step 1 Components:
Main Base
Rear Frame
Top Frame
Front Upright
Leg Extension Assembly
Pulley Mount
2 Inch Backing Plate
Hex Bolt 3/8” x 4 1/2”L
Hex Bolt 3/8” x 4 1/4”L
Hex Bolt 3/8” x 3 1/4”L
Hex Bolt 3/8” x 3”L
3/8” Flat Washer
3/8” Lock Nut
1
1
1
1
1
1
3
1
4
4
6
30
15
a.
Attach Main Base (1) to Rear Frame (2) using hardware shown.
Do not tighten hardware.
B.
Attach Leg Extension Assembly (5) to Main Base (1) using hardware shown.
Do not tighten hardware.
c
. Attach Front Upright (4) to Leg Extension Assembly (5) using hardware shown.
Do not tighten hardware.
D.
Attach Top Frame (3) to Front Upright (4) and Rear Frame (2) using hardware
shown and 2 Inch Backing Plate (10). Do not tighten hardware.
e
. Attach Pulley Mount (6) to Leg Extension Assembly (5) and Rear Frame (2)
using hardware shown and 2 Inch Backing Plate (10). Tighten all hardware
used in this step securely.
