Nautilus Be strong NS 700X, Assembly Manual

1

#  

component  

Qty

45  Power Spring Assembly  

1

46   Front Plate  

1

47   Guide Tube  

2

48   High/Low Pulley Adjuster  

1

49   Swivel Arm Assembly  

2

73   Hex Bolt - 1/2” x 5 1/4”L  

2

75   Hex Bolt - 3/8” x 4 3/4”L  

1

79   Hex Bolt - 3/8” x 3”L  

6

80   Hex Bolt - 3/8” x 2 3/4”L  

2

89   Button Head Allen Screw

3/8” x 1”L (half threads)  

1

94   1/2” Flat Washer  

2

95   3/8” Flat Washer  

18

97   3/8” Lock Nut  

9

98   3/8” x 9/32t Lock Nut  

1

Step 7 Components:

Procedure:

A. Place Guide Tubes (47) side by side on the floor with the adjustment holes facing each other.  
   Slide the Hi/Low Pulley Adjuster (48) onto the Guide Tubes (47) making sure that the Guide  
   Tubes are even and the Hi/Low Pulley Adjuster is locked into the middle adjustment holes.  
   Make sure that the plastic sleeves are still properly attached to the Hi/Low Pulley Adjuster  
   (48).
B. Attach the Guide Tubes (47) to the Rear Base Frame (1) using the hardware shown. Do not  
   tighten hardware. Carefully slide the Hi/Low Pulley Adjuster (48) to the bottom adjustment  
   hole. Align the guide rods and snug the hardware but do not tighten.
C. Attach the Power Spring Assembly (45) and Front Plate (46) to the Rear Top Frame (2) and  
   Guide Tubes (47) using the hard ware shown. Once assembled, tighten all hardware except  
   for the four bolts attaching the Guide Tubes (47) to the plates. Carefully raise the Hi/Low Pul 
   ley Adjuster (48) to the top adjustment hole. Align the guide rods and snug the hardware
   but do not tighten.
D. Connect the Hi/Low Pulley Adjuster (48) to the Power Spring Cable using the hardware   
   shown. Tighten hardware securely.
E. Slide the Hi/Low Pulley Adjuster (48) up and down the Guide Tubes (47) making sure that it   
   does not bind. If necessary, loosen the connecting hardware for the Guide Tubes (47) and
   reposition for better alignment. Once the Guide Tubes (47) are well aligned, tighten hardware  
   securely.
F. Attach the Swivel Arms (49) to the Hi/Low Pulley Adjuster (48) using the hardware shown.  
    Tighten hardware securely but allowing the Swivel Arms to rotate freely.

ASSEmBLY 

STEP 7