9
Nautilus® TreadClimber® Model TC916 Assembly Manual
GeTTInG sTaRTeD
GeTTInG sTaRTeD
selectyourWorkoutarea
Select the location where you are going to put your
Nautilus
®
TreadClimber
®
exercise machine carefully. The
best place for your TreadClimber
®
machine is on a hard, level
surface. You will need at least two feet (61 cm) on each side
and in front of your TreadClimber
®
machine, and at least four
feet (122 cm) behind it for dismount.
Make sure that the location you choose has a grounded,
3-prong power outlet within reach of the TreadClimber
®
machine power cord, preferably to the front of the machine
where you will be less likely to step on the cord during
dismount.
noTe:
The TreadClimber
®
machine is designed to plug into grounded, non-GFI outlets only. To determine if your
outlet or circuit breaker is GFI, look for a test and reset button on them. If they have the test and reset
button it is a GFI outlet or circuit breaker, and therefore not suitable for plugging the TreadClimber
®
machine into.
PowerPlugreceptacle
The Commercial Series TreadClimber
®
TC916 has one power plug receptacle located on the front side of the motor pan (see
Figure 1).
TurningonthePower
The TreadClimber
®
exercise machine can be turned on by moving the power switch located at the front of the machine, to
the ON position (see Figure 1).
understandingthedisplayandcontrols
The TreadClimber
®
console display is a computerized panel used to operate the TreadClimber
®
exercise machine and see
all workout data and operational status. You should familiarize yourself with the operation of the TreadClimber
®
machine
and location of all keys before beginning use. Detailed descriptions and usage information is available in the TreadClimber
®
Commercial Series, Model TC916, Owner’s Manual.
figure 1: on/off switch & Power Plug
