C HA NG I N G T H E G A M E I N H EA LT H A N D F I T N E S S
™
6
9. Rotate the elliptical mast into the proper position,
taking care not to pinch the electrical cable at the bottom
in the process
(see Figure 1).
10. Connect the electrical cables coming out of the front bottom fl ange of the mast assembly to the electrical
cables coming out of the front fl ange of the main frame center tube (see Figure 1). The color-coded cables
snap together with basic male/female connectors for corresponding cable colors.
11. Install and tighten (4) 3/8”-16 hex head screws, (4) 3/8” fl at washers, and (4) 3/8” lock washers into front
bottom fl ange of the upright and the front fl ange of the main frame tube. Take care not to pinch the electrical
cable during this process. This requires a 9/16” hex socket wrench.
12. Install the front left and right covers and align the holes at the side. (See Figure 1).
13. Secure the front bottom left and right covers with (10) #10-32 Phillips head screws. This will require a #2
Phillips head screw driver.
Figure 1
Electrical Cable
Take care not to pinch when assembling.
Connect before securing fl anges together.
• 3/8”-16 Hex Head Screw
• 3/8” Lock washer
• 3/8” Flat Washer
Front Right Cover
Front Left Cover
#10-32 Phillips Head Screws
