Check data cable integrity
All wires in cable should be intact. If any
are cut or crimped, replace cable.
Check data cable
connections/orientation
Insure cable is connected securely
and oriented properly. Small latch on
connector should line up and snap into
place.
Console displays "E2" error code
Console Electronics
If tests reveal no other issues, Console
should be replaced.
Check data cable integrity
All wires in cable should be intact. If any
are cut or crimped, replace cable.
Check data cable
connections/orientation
Insure cable is connected securely
and oriented properly. Small latch on
connector should line up and snap into
place.
Check magnet position (requires shroud
removal)
Magnet should be in place on flywheel.
If no magnet is present, replace the
flywheel or the entire base unit (if unable
to replace flywheel).
No speed/RPM reading, Console displays
"E3" error code
Check RPM Sensor (requires shroud
removal)
RPM sensor should be aligned with
magnet and connected to data cable.
Realign sensor if necessary. Replace if
there is any damage to the sensor or the
connecting wire.
Check data cable integrity
All wires in the cable should be intact. If
any are cut or crimped, replace cable.
Check data cable
connections/orientation
Insure cable is connected securely
and oriented properly. Small latch on
connector should line up and snap into
place.
Reset Machine (if equipped with reset
button)
Unplug unit from electrical outlet for 3
minutes. Reconnect to outlet. After the
Console powers up, press "reset".
Check magnet position (Technician only-
requires shroud removal)
Magnet should be in place on flywheel.
If no magnet is present, replace flywheel
or entire base unit.
Console shuts off (enters sleep mode)
while in use
Check RPM Sensor
Contact Customer Care for further
assistance.
Check data cable integrity
All wires in cable should be intact. If any
are cut or crimped, replace cable.
Check data cable
connections/orientation
Insure cable is connected securely
and oriented properly. Small latch on
connector should line up and snap into
place.
Fan (if equipped) will not turn on or will
not turn off
Reset Machine (if equipped with reset
button)
Unplug unit from electrical outlet for
3 minutes. Reconnect to outlet. After
Console powers up, press "reset".
Check leveler adjustment
Leveling feet may be turned in or out to
level bike.
Unit rocks/does not sit level
Check surface under unit
Adjustment may not be able to
compensate for extremely uneven
surfaces. Move bike to level area.
20
20
20
