Nautilus T628, Assembly Manual / Owner'S Manual

34

 • Always attach the Safety Key Clip to your clothing during workouts.

 • If there is an emergency, pull out the Safety Key to shut off the power to the Belt and Incline Motors. This will quickly 
stop the belt (brace yourself- this is an abrupt stop) and clear the workout. Push the PAUSE/STOP button to stop the 
belt and pause the program.

7.  

Push the USER button to select the desired User for the workout.

.  

 Select your workout using the PROGRAMS button and the Decrease/Increase buttons.

9.  

With your desired workout shown, push the OK button. 

10. The Console will ask a series of questions to customize the workout. When the Console displays the “READY ?” 
prompt, push the START button. The Console will display “RAMPING UP” as the Walking Belt gets up to speed. Be sure 
to carefully step onto the walking belt. 

The belt will only move after a 3 second, audible beep countdown.

Always use the handlebars to step on or off the treadmill, or when the incline or speed change.

,IWKH6RXQGKDVEHHQPXWHGWKH&RQVROHZLOOGLVSOD\WKH³$8',22))´SURPSWIRUDIHZVHFRQGV

 To perform an emergency dismount, grab onto the Front or Side Handlebars and safely step onto the Side 

)RRW3ODWIRUPV%ULQJWKH:DONLQJ%HOWWRDVWRSDQGFDUHIXOO\VWHSRIIWKHPDFKLQH

Note:

 Your treadmill comes equipped with a durable, high quality walking belt designed to provide many hours of 

reliable service. The walking belt on a treadmill that has not been operated for a length of time, either in factory 
packaging or after assembly, can e

[

hibit a “thumping” noise when started. This is due to the belt taking on the curve 

of the front and rear rollers. This is a common occurrence and does not indicate a problem with your machine. After 
the treadmill has been used for a short period of time the thumping noise will discontinue. The amount of time will vary 
depending on the temperature and humidity of the environment where the treadmill is placed. 

3RZHU8S,GOH0RGH

The Console will enter Power-Up / Idle Mode if it is plugged into a power source, the Power Switch turned on, and the 
Safety Key is properly installed.

 Note: 

if the Safety Key is not installed, the machine will allow the User to perform all activities e

[

cept to activate the 

Walking Belt. The Console will display the reminder to insert the Safety Key ( “ + SAFETY KEY” ). Once the Safety key 
is installed, the START button will need to be pushed again to begin the selected Workout.

Auto Shut-Off (Sleep Mode)

If the Console does not receive any input in appro

[

imately 5 minutes, it will automatically shut off unless in Demonstration 

mode.
Push any button to start (wake up) the Console. If your machine is in Demonstration mode, hold down the PAUSE/STOP 
button and Decrease button together for 3 seconds.

To disconnect, turn all controls to the off position, then remove plug from outlet.

Initial Setup 

During the 

¿

rst power-up, the Console should be set up with the date, time, and the preferred units of measurement. 

1.  

Date: Push the Increase/Decrease buttons to adjust the currently active value (

À

ashing). Push the Left/Right buttons 

to change which segment is the currently active value (month / day / year). 

2.  

Push OK to set.

3.  

Time: Push the Increase/Decrease buttons to adjust the currently active value (

À

ashing). Push the Left/Right buttons 

to change which segment is the currently active value (AM or PM / hour / minute). 

4.  

Push OK to set.