DS, BM
4/15/14
NTV-DOC141
rB6
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
4 |
P a g e
6.
Connect the following wires from the provided
Power/Signal Harness
:
Pin #, Color
Description
Connect to:
7
Black
Ground (-)
Ground (-) @ Radio Harness
1
Red
Constant 12v (+)
12v (+) Constant Power
2
Blue
Remote in 12v (+)
Remote OUT from radio (blue/white)
7.
Connect a full range RCA output from the aftermarket radio and connect it to the RCA
inputs of the OPTI-1.
Note: A short RCA cable is sometimes needed in order to position
the OPTI-1 in a location that does not hinder the depth of the radio opening.
8.
Plug the OPTI-1 power harness in the unit and proceed to the next section
‘Radio &
antenna connections’
Radio & Antenna connections
1.
Refer to the installation guide from the aftermarket head unit for wiring information.
2.
The constant power from the aftermarket head unit (Usually yellow) must be connected
to a circuit that can supply the radio with sufficient current (check the specifications in
the radio installation manual. Usually the demand does not exceed 10 to 15 AMPS.)
Suggested connection points are the
driver’s side dash fuse box
on E, CLS and SLK
vehicles,
the front or rear fuse box
on S and CL vehicles and from the
rear fuse and
distribution block
on the SL (There are two clips on the false door cover that will allow
access to the fuse and distribution block on the SL).
MAKE SURE THAT YOU FUSE THE
CONSTANT POWER CONNECTION PROPERLY!
3.
Connect the accessory wire from the aftermarket deck (usually red) to the front
cigarette lighter accessory power (black or red with a stripe). Use a multi meter to verify
accessory at this location prior to making a connection.
4.
Connect the ground (usually black) from the aftermarket radio harness to the ground
(brown) wire at the front cigarette lighter.
5.
Connect the illumination or dimmer wire from the aftermarket power harness (usually
orange or orange/white) to the illumination wire at the front cigarette lighter (grey with
a blue stripe). Use a multi meter to verify the wire is illumination prior to making a
connection.
