1 |
P a g e
PCM3-997-Media
NTV-KIT114/283
Adds iPod, AUX, USB-media and Bluetooth to 2009 and Up Porsche 997 vehicles equipped with PCM3 radios
Radio Removal and Installation
Radio Dash Images
1.
On either side of the center console there will be a
carpeted panel. Unscrew the panel (T27 Torx ) and
set aside Remove two T20 screws on each side of
the vinyl (leather) panels that were exposed by
removing the carpeted panel. After the screws have
been removed, take the plastic/vinyl cover and pull
toward rear of vehicle and remove. (Repeat steps for
both passenger and drivers side panels).
2.
There will be (4) Allen screws (2 on each side of the
radio) on the side of the radio. Turn 1/4 turn counter-
clockwise to release the radio.
3.
Pull the radio straight toward the back of the vehicle
and proceed with the installation.
4.
Remove the fiber optic connector from the factory
harness by gently prying up on the locking tab with a
pick tool. With the fiber unplugged from the factory
harness. Plug in the supplied T-harness to the
factory harness. Plug in the Interface module into the
8-Pin connector on the T-harness. Secure the
Interface module in the dash.
3950 NW 120th Ave, Coral Springs, FL 33065
Tel. 561-955-9770 Fax. 561-955-9760
www.nav-tv.com
info@nav-tv.com
PCM3-997-Media 5-19-2014
Rev 2 TY, BM
NTV-DOC
180
Kit Contents
SIR-PCM3 Module
NTV-ASY144
SIR-PCM3 Power Harness
NTV-ASY007
MOST Fiber
NTV-ASY003
Sirius Tuner (SCC1)
NTV-INT021
Center Console Dock
NTV-
MIS00
3
PCM3
Media
Module
NTV-ASY1
71
Dock USB Cable
NTV-
CAB018
Dock Harness
NTV-ASY
134
Ipod Cable
NTV-
CAB017
PCM3 T-Harness
NTV-
HAR1
02
Included in NTV-KIT283 only
USB Cable
NTV-
CAB009
