BHM
01/04/19
NTV-DOC336
3 |
P a g e
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
RGB-BNTv2 Ribbon Installation
1.
Remove the factory radio: remove the trim surrounding the radio,
then remove 5 screws that secure the radio into the dashboard. Pull
the radio from the dash, disconnect all connected harness and bring
it to a clean bench with a soft surface.
2.
Separate the front half of the radio from the back half by removing
2 torx screws from each side of the radio.
3.
Carefully disconnect the ribbon that connects to the
screen indicated by the red arrow. Disconnect the
other 2 cables indicated by the yellow arrows.
4.
Insert the free end of the ribbon from the BNT board
into the radio’s display connector (near 2 small caps).
Be certain the pins are facing the correct direction,
and that it is seated firmly.
5.
Connect the free end of the Factory LCD ribbon
that was disconnected in step 3 to the other side of
the BNT board.