BHM
01/04/19
NTV-DOC336
4 |
P a g e
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
6.
Use 3M double sided stick tape (or equivalent measure) to secure
the BNT board down to a nearby flat surface.
7.
Remove the top metal cover from the back half of the radio. Run
the RGB cable (leave slack) on the top, left side of the radio like
shown. Use a small zip tie to secure the cable from being pulled.
8.
Replace the top metal cover to the back half of the radio.
The RGB cable should fit through an unused access hole like
shown.
9.
Connect the free end of the RGB cable to the 10-pin port on the
BNT module.
RGB-BNTv2 Power Connections
1.
From the provided
RGB Power Harness
, connect the
black wire
to chassis ground (-) and
the
red wire
to an ACC 12v (+) source (cigarette lighter, etc).
2.
Connect the
white/red wire
(INPUT 1)
to a 12v
(+) reverse wire. Any time this wire
receives 12v (+), the video signal provided to
VIDEO 1
will be displayed on the media
screen (while in NAV mode from the radio).
3.
Optional:
If adding a secondary AUX Video source to this vehicle, connect the video
signal RCA to the
VIDEO 2
port on the
Power Harness
. This source can be viewed at any
time when the
white/blue
(INPUT 2)
wire receives 12v (+).