BHM
08/19/15
NTV-DOC232
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of its product.
If you do not agree, please discontinue use immediately and return product to place of purchase. This product is intended for off-road use and passenger
entertainment only.
5 |
P a g e
6.
With the fuse block pulled out, splice the
yellow wire
from the provided
Power/CAN harness to a constant 12v (+)
wire:
7.
Replace the fuse block into the sub-dash
once complete.
8.
Locate the
yellow & yellow/white
wires in the 3-pin CAN plug
from step 3 and
cut these wires in half.
Leave enough room to
solder to each side of each wire when doing this.
9.
Solder the following wires in the proper direction to each cut
wire:
10.
Insulate each wire, and reconnect the 3-pin plug to the CAN-
BUS bank.
W222-VIM wire
PIN #
Connect to CAR’s
Direction
White/Blue
8
White/Yellow
Harness Side
White/Brown
9
White/Yellow
Plug Side
Blue
17
Yellow
Harness Side
Brown
18
Yellow
Plug Side
X
X
