7.
What safety feature does a transmission jack have to prevent the transmission
from falling?
A.
Saddle
B.
Chains
C.
Straps
D.
All the above
8.
When removing the transmission, what should you do before removing any cross
members?
A.
Place a jack under the transmission only
B.
Place a jack under the engine only
C.
Place a jack under the engine and transmission
D.
Get someone to hold the engine
9.
What tool might you use to drive out the counter shaft when disassembling the
standard transmission?
A.
Five-pound hammer and spike
B.
Arbor shaft
C.
Puller
D.
Counter shaft driver
10.
What parts are generally recommended to be replaced during reassembly of the
standard transmission even though they may show no indication of any problem
before disassembly?
A.
Seals and gears
B.
Sprockets and bearings
C.
Bearings and seals
D.
Seals and gaskets
11.
One of the most tedious procedures is replacing needle bearings in countershaft
gears. What can you do to make this procedure easier?
A.
Coat the bearings with heavy grease
B.
Coat the bearings with light grease
C.
Use a special needle bearing holder
D.
Get someone else to do it
12.
(True or False)
When installing the standard transmission, one helpful action is
to use the transmission bolts to draw the transmission into the clutch housing.
A.
True
B.
False
NAVEDTRA 14050A
8-101