26.
What type of grease should be applied when pumps are mounted directly to the
PTO output?
A.
Anti-seize
B.
Axle
C.
Silicone
D.
Lithium
27.
The basic driveshaft assembly is made up of U-joints, slip splines, propeller
shafts, and
.
A.
drive splines
B.
yokes
C.
differential
D.
transmission extension
28.
In what type of driveline configuration are the working angles of the U-joint's
driveshaft equal, but the companion flanges and/or yokes are not parallel?
A.
Parallel-joint
B.
Parallel-shaft
C.
Broken-shaft
D.
Broken-back
29.
(True or False)
The faster a driveshaft turns, the higher the allowable working
angle rises.
A.
True
B.
False
30.
What two components of the driveshaft must be perfectly in line with each other
to be in phase?
A.
Slip splines
B.
Yokes
C.
Zerk fittings
D.
Driveshaft bolts
31.
What is the typical minimum OEM specification, in inches, when you are
inspecting the looseness across the U-joint bearing caps and trunnions?
A.
.0006
B.
0.006
C.
0.060
D.
0.600
32.
Heavy-duty driveshafts typically use what type of grease?
A.
Silicone-based extreme pressure
B.
Water-soluble
C.
Bearing
D.
Lithium soap-based extreme pressure
NAVEDTRA 14050A
8-104