40.
What tool is used to measure operating angle on the driveline?
A.
Builders level
B.
Planimeter
C.
Inclinometer
D.
Incline plane
41.
What can be installed to correct the U-joint operating angle on a vehicle with leaf
spring suspension?
A.
Axle shims
B.
Axle risers
C.
Leaf spring jacks
D.
Torque rod shims
42.
Driveshaft runout requires the taking of fine measurements, and generally the
tool used is a/an
_.
A.
inside micrometer
B.
driveshaft caliper
C.
dial indicator
D.
dial gauge
43.
How many degrees should the machined shoulder of a half-round yoke or yoke
bores in a full-round yoke be to the centerline of the shaft the yoke is attached
to?
A.
30
B.
60
C.
90
D.
180
44.
(True or False)
The PTO will always be driven by a driveshaft.
A.
True
B.
False
45.
As you go through the steps to remove the differential, as a safety precaution,
you should not remove the axle retaining nuts until you have loosened which
components?
A.
Capscrews
B.
Flanges
C.
Tapered spring dowels
D.
Axle shafts
NAVEDTRA 14050A
8-106