46.
When removing the rivets on the crown gear, use a drill bit that is
inch
smaller than the body diameter of the rivets.
A.
1/32
B.
1/16
C.
1/8
D.
1/2
47.
When removing the drive pinion and bearing cage, what tool(s) might you use if
the yoke or flange is tight on the pinion?
A.
Two screw drivers
B.
Pry bar
C.
Hammer and chisel
D.
Puller
48.
When removing the pinion oil seal during disassembly of the drive pinion and
bearing cage, what is the procedure if it is a one-piece design?
A.
Reuse
B.
Discard
C.
Do nothing
D.
Inspect closely
49.
Aligning the oil slots in the shims with the oil slots in the bearing cage and carrier
is part of the installation of which component(s)?
A.
Crown gear and differential assembly
B.
Crown gear only
C.
Bearing cage only
D.
Drive pinion and bearing cage
50.
What can you do to the ring gear for easy installation?
A.
Expand by heating in a tank of water
B.
Expand by heating with a torch
C.
Contract by placing in a freezer
D.
Contract using a CO
2
extinguisher
51.
What is the proper procedure for the fasteners after installing the hardware into
the case halves of the differential?
A.
Tighten in a clockwise pattern
B.
Tighten every other counter clockwise
C.
Tighten in an opposite pattern
D.
Tighten in a staggered pattern
NAVEDTRA 14050A
8-107