52.
To install the bearing caps over the bearings and adjusting rings, tap each cap
into position with which tool?
A.
Light leather mallet
B.
Plastic mallet
C.
Rubber mallet
D.
All the above
53.
What should the end play measurement typically be, in inches, when you are
checking a rebuilt power divider with reused components?
A.
0.003-0.007
B.
0.03- 0.07
C.
0.013-0.017
D.
0.13-0.17
54.
The runout of the crown gear must not exceed
inches.
A.
.0008
B.
0.008
C.
0.080
D.
0.800
55.
(True or False)
If the used crown and pinion gearset is installed, you can use the
setting that was measured before disassembly.
A.
True
B.
False
56.
How should the correct pattern appear when you are checking the tooth contact
pattern on a new gearset?
A.
Correct pattern will have a pocket
B.
A pocket will be at the toe-end of the tooth
C.
Pattern will be around the edge of the tooth
D.
Pattern will be well centered on the crown teeth
57.
There are a couple of variations of the semi-floating axle. Which type is
sometimes referred to as the C-lock axle because of the shape of the locking
clip?
A.
Tapered roller bearing
B.
Roller bearing version
C.
Encased semi-floating
D.
Pinion version
58.
The full-floating axle will typically be found on what type of vehicle/equipment?
A.
Sedans
B.
Small pickups
C.
Large, slow moving off-road
D.
Track equipment
NAVEDTRA 14050A
8-108