19.
While conducting a starter insulated circuit test, what maximum allowed voltage
drop is the norm across the length of a cable?
A.
0.01
B.
0.10
C.
1.00
D.
1.10
20.
During a starter ground circuit resistance test, the measured voltage loss
exceeds 0.2 volt or the loss given by the manufacturer's specifications. This loss
can result from which of the following problems?
A.
Loose starter bolt
B.
Poor battery ground terminal post connector
C.
Damaged undersized ground system wire
D.
Each of the above
21.
What component of the ignition system boosts battery voltage to a much as
60,000 volts?
A.
Alternator coil
B.
Ignition switch
C.
Ignition coil
D.
Battery booster
22.
(True or False)
An electronic ignition is more dependable than a contact point
because there are no mechanical breakers to wear or burn.
A.
True
B.
False
23.
A solid-state chip or module that produces an electrical signal when triggered by
a slotted wheel is called what?
A.
Hall-effect pickup
B.
Trigger wheel
C.
Permanent magnet
D.
Pickup coil
24.
In the distributorless ignition system, what component consists of two or more
ignition coils?
A.
power distribution module
B.
distributorless coil module
C.
ignition module
D.
electronic coil module
NAVEDTRA 14050A
6-68