NavePoint 2U Owner'S Manual Download

Page: 5 / 6

www.NavePoint.com

customerservice@navepoint.com

-Mounting the Enclosure to the Wall

Remove Front Cover

Mount to Wall

Disassemble the Front Cover by removing 2 M4 Screws on each side of Front Cover.

Attach the Enclosure to a wall or other suitable mounting surface using 4 appropriate mounting screws/anchors
(not included).

Warning: The enclosure can hold up to 60 pounds evenly distributed. Make sure wall surface can hold weight
of the enclosure and equipment.

Summary of Contents for 2U

Page 2: ...www NavePoint com 2 customerservice navepoint com 1 Feature Identification 1 Perforated Front Cover 2 Bottom Panel with cable access Holes 3 Mounting Rails 4x 4 Cable Tie Mounts 4x 5 Vents ...

Page 3: ...ch increments for mounting depths 1 Disassemble the Front Cover by removing 2 M4 Screws on each side of Front Cover 2 Remove the screws fastening each of the mounting rails to the enclosure 3 Slide the mounting rails to the desired depth and reattach them Model Mounting Depth Adjustable 2U 16 to 22 406 4mm to 558 8mm 4U 16 to 22 406 4mm to 558 8mm ...

Page 4: ...ttom Panel Bottom Panel can be removed for equipment that is longer than 22 in Cable Access and Management 4 Cable Tie Mounts are provided The Bottom Panel of the enclosure has 4 circular cable access ports for convenient cable management Diameter of each hole 28mm ...

Page 5: ...le the Front Cover by removing 2 M4 Screws on each side of Front Cover 2 Attach the Enclosure to a wall or other suitable mounting surface using 4 appropriate mounting screws anchors not included Warning The enclosure can hold up to 60 pounds evenly distributed Make sure wall surface can hold weight of the enclosure and equipment ...