116
Version 2.0
Operator’s Manual
Configuration
waypoint by crossing the bisector line of an acute angle (providing
you are within 0.2 NM of the waypoint) or an obtuse angle between
your present course line and the next leg of your route.
Manual:
Passing the waypoint can only be accomplished by manually skip-
ping a waypoint. Refer to the
Skipping and Unpassing Waypoints
in the
Route
section of this manual.
This is a great way to perform station keeping maneuvering. Refer
to the
Plot Screen Use Examples
in the
Plot
section for further
details on this application.
Distance:
Passing the waypoint is determined by reaching an imaginary circle
around the waypoint, the radius of which you can define in WPT
Pass Distance. The default value is 0.10 Nm.
If you set this distance to 0.00, you will never pass the waypoint.
This is a great way to perform station keeping maneuvering. Refer
to the
Plot Screen Use Examples
in the
Plot
section for further
details on this application.
Bisector Line:
Passing the waypoint is determined by reaching the bisector line
of an acute or obtuse angle between your present course line
and the next leg of your route.
Perpendicular Line:
Passing the waypoint is determined by reaching an imaginary per-
pendicular line from your present course line.
Approach Alarm:
Causes an alarm to sound if your position is within the radius
defined in
Approach Distance
(below) when
Yes
is selected. To
disable the alarm, select
No
(the default condition) with the
Change
softkey.
Summary of Contents for MX420
