Version 2.0
129
Configuration
Operator’s Manual
(default) bit serial data.
Stop Bits:
This allows you to match the printer’s requirement of
1
(default) or
2
stop bits.
Parity Check:
This allows you to match the printer’s requirement of
None
(default),
Even
or
Odd
parity.
Handshake:
This allows you to match the printer’s requirement of
No
(default),
XON/XOFF
or
HW
(Hardware; CTS, RTS ).
ROT (Rate of Turn)
The ROT configuration menu is only available in MX420 models with
the AIS or MKD feature enabled. It is not available in standard MX420
models. The “ROT connected” mode can be toggled to YES or NO, by
pressing the
E
key and then pressing the ‘
Change
’ softkey.
Data input port no:
...1 (valid port selections are 1,2,5 through 10)
Alarm if no data: ....No
(‘Yes’ value sets the alarm to sound if no ROT
input data is detected in 5 seconds)
Note: Only IEC type approved ROT information can be used by
the AIS transponder. Rate-of-Turn messages designated
by talker device ID “$TIROT” are required.
Security
The Security screen allows you to lock out the
E
key in order to keep
crew members or visitors from changing settings that you have made.
Once this feature is enabled, a press of the E key will require the correct
password to gain access. To disable the security functions, you will be
prompted to enter a 5 digit password. You will then be prompted to
reenter the password. The security function is then disabled until you
enter a new password through the
CFG1 Security
screen again. Be
sure to keep your password in a safe place. If you loose your pass-
word, you will need to call the factory to reset the security feature.
Summary of Contents for MX420
