132
Version 2.0
Operator’s Manual
Configuration
Alarm If No Data:
Allows you to receive an audible and visual alarm if
NMEA 0183 data is not being received on the data port at regular
intervals (typically every few seconds). The available choices are
Yes
(default) or
No
.
AWA Offset:
Allows you to input a constant angle correction value.
AWS Correction Factor:
Allows you to input a wind speed correction
factor.
Input Sentence
: Specifies the NMEA 0183 data sentence to read the
depth data from. The available choices are
Any (default)
,
MWV
, or
VWR
sentence. It is better to specify the appropriate sentence,
because more than one method of reporting wind may be available
on the port.
Wpt & Rte Input - Uploading Waypoints into the Receiver
This screen enables the input data port to receive waypoints and routes
from a chart plotter, PC (VMS), or other device to the receiver. You can
receive this data through any of the user NMEA 0183 input data ports.
Load the WPL sentences first, then the RTE sentences. Change
Trans-
ducer Connected
from
No
(default) to
Yes
and select the appropriate
port. Refer to the
Waypoints - Uploading Waypoints from Other De-
vices
section of this manual for more details on the software interface.
Refer to the
Installation & Service Manual
for hardware interface.
Summary of Contents for MX420
